A setup built around the work
Fabrication, machining and assembly — a practical workshop where machines are built, checked and prepared for dispatch.
Fabrication to dispatch under one roof
Cutting, bending, welding, machining and assembly happen in one place at our unit. That makes it possible to check fit and alignment at every stage — and catch a mistake where it happens.
The setup is not made to look big; it is made for the work. Where machine size or requirement changes, jigs and fixtures maintain repeatability.
See the machinery rangeFour parts of the work
Every section has its own job — and all of them connect.
Fabrication
A cutting, bending and welding section where frames, plates and chambers are built. Jigs and fixtures bring repeatability.
Machining
Machining support for parts such as shafts, hubs and bearing seats so fit and alignment stay correct.
Assembly
Parts are fitted in the assembly bay — drive alignment, belt tension and clearance of moving parts are checked.
Dispatch
The machine is run and checked, then packed and dispatched. Loading is planned according to the site.
What we do ourselves — and what comes from the network
Our focus is practical capacity, not big claims. For work we do not do ourselves, we take support from a trusted network — and tell the customer upfront.
Plan a visitQuestions about infrastructure
Common questions about visits, the machine range and custom work.
Can I visit the factory?
Yes, a visit is possible. Call before coming to confirm a time so the concerned person is available and you can see the machine setup.
Which machines are built here?
Both agricultural machinery and brick kiln machinery are fabricated and assembled here. Some specialised parts are supplied through our network.
Do you work on custom requirements?
If the requirement is clear and feasible, a custom size or setup can be discussed. Send an enquiry with a drawing or sample.