Casting Parts
Casting components made to a drawing or sample — hubs, housings, pulleys and custom parts for agricultural and brick kiln machinery.
Fit and finish depend on the casting
Not every part is made by fabrication. Hubs, housings, pulleys and some brackets are better cast because a complex shape can be repeated consistently. A casting only delivers value when dimensions and machining are correct.
We source casting parts for our own product range and coordinate requirements from a customer's drawing or sample. Share the drawing, material and quantity, and we will confirm feasibility, rate and timeline.
Send a part enquiryWhich parts are available
Every group includes wear parts and replacement components. Send a photo or sample for an exact match.
Hubs and housings
Bearing housings, hubs and mounting parts that fit between the shaft and frame.
- Bearing housings
- Wheel hubs
- Mounting brackets
- Shaft collars
Pulleys and drive parts
Pulleys and coupling components for belt drives, balanced and machined.
- V-belt pulleys
- Couplings
- Bushes
- Spacers
Wear castings
Wear-resistant cast components for crusher and mixing sections.
- Hammer blanks
- Liners
- Blade holders
- Wear plates
Custom components
Small custom casting parts made to a drawing or sample for a machine fit.
- Custom brackets
- Machine feet
- Guards
- Adaptors
Details needed for a casting enquiry
A part matches correctly only when both the machine and size are clear. These four details speed up the enquiry.
Drawing or physical sample
Material specification
Quantity and repeat requirement
Whether machining is needed
Casting Parts — questions and answers
Common questions about part identification, quantity and delivery.
Can a casting part be made without a drawing?
If a sample is available, measurements can be taken and a drawing prepared. Making an exact casting from a photo alone is difficult because dimensions and fit matter.
What is the minimum order quantity?
It depends on the part type and machining requirement. Both small quantities and repeat orders can be discussed.
Is machining done after casting?
Machining is necessary where fit and bore accuracy matter. Mention at enquiry stage whether you need a finished part or a raw casting.
What is the delivery time?
It depends on part complexity, quantity and machining. The exact timeline is shared before the order is confirmed.